tomb321

Has the Vectorization function been removed from VM Cut? I cannot find it anywhere in the software, even following videos. In the USCutter copy it states it is there. In the VM compare file, it shows it not having the function unless you have the LTR and above.

I found it. LaserPoint is found in the Wizard but not in the Vinyl Spooler. I've got it working now and calibrated. Now if there were only a SB--->VM cheat sheet, that would be great. Thanks guys.

Downloaded that version just now and they must have removed it. cutter.bmp

I downloaded the demo from USCutter before posting. The LP is not an option, only LPII. I've been using this cutter for 9 years with SB. Selected the LPII and tried both serial and USB and cannot get it recognized. Wondering if there are some other settings I need to do to get it to work.

Does VinylMaster work with LaserPoint (not LPII)?

Can't flip it, it's concave. I ended up buying double side tape. Works great.

I wonder if I can flip it over and it work. I'll try it when I get home, if I remember.

No, I haven't messed with it. Still using the old one. I plan to buy some double-side tape to keep in place.

No, Tom L.

Narrow enough that I could see it was visibly not going to work, maybe 1/16". I took the new strip out of the package and started to remove the old strip but stopped after I had 2 inches out because I could tell it was different. Continued until I had about a foot pulled up so I could see if the new one would work. Sure enough, it does not snap in or require any force. It just curled up out of the track.

Does any one know where to buy a cutting strip that fits the LP? Bought one from USCutter. Sent me one that doesn't fit (it's long enough just not wide enough), they say to use double sided tape to hold it down

Looking for this font. My hd crashed and it doesn't seem to come with SB. Thanks Tom

I had the issue with the design not cutting and the machine "waiting". I was using the serial cable and it was still causing this. I changed in SignBlazer for Flow Control to be "Hardware" instead of X on/X off, software, or what other options there are (not at my PC at the moment). Fixed the problem and has been fine since.

Not in Alpharetta, but a few minutes to the east in Norcross. http://www.jsisign.com/

Finally found the landscape/portrait solution. Go to FILE - PRINT and click on the ROTATE button at the top left. This toggles the landscape/portrait aspects. Print the transfer. This will carry over to the CUT A PRINT function. Hope this helps. Tom