wingkender

Members
  • Content Count

    1
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral

About wingkender

  • Rank
    Newbie
  • Birthday 01/01/1

Profile Information

  • Gender
    Not Telling
  1. I use out cutter for a Graphics Design class here at CHS. I initially installed the cutter on an older computer with the parallel cable. I could not get the serial or the usb cable to communicate with the cutter. Well now I have a new computer with Windows 7 and no parallel connection. I am struggling with the communicating with the cutter. I can not find any of the software that was sent with the cutter but I did go on-line and download from US Cutter what I needed. Still no communication. Then on my NEW computer the hard drive crashed and I am back a square one. Before I download anything and start again, does anybody have a link to a page or discussion about the best way to set this up in 7, newer or better drivers, or better software to use for cutting? I have installed to Adobe CS4. Thank you.