When cutting Black HTV or even Navy Blue, my roland will cut part of the design and then stop. When i move the vinyl to try it again, it will cut part and stop in the same spot. I have turned it off, unpluged the printer cable, cleaned it with canned air, blew out the blade holder and it still does it. I have about 30 shirts to make and i am wasting a ton of vinyl. HTV is not cheap.
Since it only happens on black and navy, i figure it is an EYE issue. I covered one sensor with light grey vinyl and it still does it.
NEED HELP, Please.
A newbie to the group not to Roland. this is my second one. the first one is up in the attic, i think i am going to go get it. I have been using them since 2012..