lucaquick
Members-
Content Count
16 -
Joined
-
Last visited
Community Reputation
1 NeutralAbout lucaquick
-
Rank
Member
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
-
I use illustrator and with the signcut plugin i export and send the file to signcut software
-
Thank you so much for your help. Today afternoon I'll check in my signcut software!
-
Yes. But the text on the white vinyl, are correct courved because the corners of the "font" utilized is rounded. but i can improve more better the lines with your advice
-
New test and new better result.
-
i partly solved and improved the problem! see the result in the pictures! I removed the front plastic case, and tightened all the screws well! The result, i think look very well!...also given the small size of the writings "ASD" in the DOG vinyl What do you thinks? Any suggestions for better more the final result?
-
this is the blade sticking in the holder!
-
I tried put 0 offset or 1 offset but the result look similar! which one blade is better 30°/45°/60°? can it depend on that? or can depend on the position of the tool? or there is a programme better for adjust the offset?
-
The holder arm is the same for cutting tool and pen tool, there are only two holes for instal the tools Why with pen the looks is better?
-
I send the test result. The first and second starting from the right are with the cutting tool installed in the rear position of the plotter the others are with the toll installed on the first hole of the plotter they look the same to me. The second photo show the difference between the pen tool and the cut tool both of them with the tool in the first front hole with pen is better
-
Where can i adjust the offset? I use signcut
-
Tomorrow i'll send the picture of the test
-
Not good! The square outside better, but in the square inside the corner are a little bit rounded
-
Today I changed the blade. I set the blade and I tested It, this Is the result. Same problem! If you can, help me! Thank you so much I tested with the pen tool and the result Is better, the corner and the Lines are correct.
-
I solved the USB Driver problems! BUT NOW i have a new problem!!! When I cut the vinyl the lines are very croocked!!!! I think the problem is the offset Is it possible resolve this? The range correct for offset are from 0 to 1, inside the software it's set on 0,25 What can I do to have a correct cut?
-
for download it they ask me the credit card! I wouldn't put it those credentiality Any solutions? p.s. I tried with credit card, but after the download site doesn't work