vxtacy

I’m new to vinyl cutters so please excuse any misunderstandings but I’ve recently purchased a vinyl cutter that’s not cutting straight lines even in the test cutting and I would please like some help if anyone would be willing, I’d be so grateful, jay

Managed to get my offset actually changing by deleting to reset the signcut folders in my appdata , far right is 1mm and middle .24mm -and left is .118

i've adjusted further to make sure its a lot less than that now! thank you:)

i havent been able to locate an offset option on the machine

0.03 to 1mm

i'm just on a livechat with the support currently! these are what i see on my software, and of course! that makes perfect sense, i'm currently a student and i've always used illustrator as its an amazing software and i dont think i'd wanna use the signcut software to make the designs unless absolutely necessary

Hello wildgoose! Thank you for coming back to help! The machine setting I’ve included down below, I believe it’s only on the software I’m able to set the offset FullSizeRender.mov

I hope so too! You guys have been so much more informative than the manual I received with the cutter 1000%

Signcut support have sent me a link to this about offset

I’m afraid I wouldn’t be able to tell you 61654462524__CE6C8917-646F-40B9-9728-F846147E88D6.MOV

That’s what I expected as the jagged edge effect didn’t occur as I’d expected from seeing how the difference should be, I’m using signcut pro 2 and blade wise

Think I used a bit too much force by my hands I’m afraid:’)

3. These are the test cuts at 0.25 and 0.35, neither are squaring off as much as I expected it to, at 0.35 the corner caught a little bit when weeding this last one is 0.13 offset

Thank you so much for the help, 1. blade test done and adjusted it to cut just the vinyl on top manually as well as a little bit of the vinyl and adjusted positioning on the blade holder on the machine to Cut just the vinyl 2. Machine cuts at 800mm/s I’ve set it to 150 mm/s and a force of 70 which seems to work well currently

Thanks for posting! What should the offset be? I’ve tried 0.01 to 0.30 and I’ve pulled some slack and tried as well as putting already cut vinyl in and both do the same thing with rounding it off