BlueLine GraphFX

I will try your suggestion of Sign Blazer. I do have some old vinyl (over 10yrs) and some that is days old. When I mean Morse code , I'm talking about the machine movement. Not the cut vinyl. It's like the speed is set to 1/2mm a sec! Instead of a nice continuous flow.

Thank you both for the help! I might give it 1 more try before I call support for signcut. I just noticed my VinylMaster Pro supports my PCut. Just maybe a New laptop and software is what it needs! Fingers crossed!!

Adobe is much more advanced/powerful then VM in the design dept. I will give your suggest a try. Thanks for the replies! Hope your Holidays were good!

Every time I try this It either cut the square of the flag out of my "Goat" or it puts the flag on the outline itself!

That is the quick way to describe it. LOL I have only used my pcut about 2 dozen times. I was using it as a hobby, when my work & family schedule changed and I was unable to use it anymore. With that said, I wanted to get back into it so I dusted off my dedicated laptop with Signcut Pro 1, renewed my lic and went to cut out some simple text. The cutter didn't do its smooth and fast cutting, it was a dash,dash,dash,dash…..etc. the simple text of "Test", 1"x 2" took the cutter about 6 minutes to complete! Yes, 6 minutes!! It was also very hard to weed due to all the little stop and go. I've been using the same laptop that has NOT been updated since the last time it cut fine. (4-5 years ago). I use this computer , because it has all my art work and clip art and full version of Adobe Suite I purchased on I've changed out the USB cord twice with same results. So I update all drivers and same results. I would like to get this machine up and working again if possible. PS I just purchased a new laptop & a smaller cutter (Titan 3 -15" with VM Pro) so I can start doing small jobs right away but need/want my 24" wide cutter for bigger jobs. Thank you in advance for any and all suggestions of help.

Sorry for such a newbie question but, how/can I fill an object (.jpg) with another (.jpg) example: I have a .jpg of a dog and want to fill it with an American flag .jpg I tried tracing the dog then fill with object (Flag.jpg). All it did was fill the outline with the flag. lol I need the inside filled.