Thanks slice&dice for the link to v7.0.0. I had a triplite hooked up to another plotter but did not have a cable that would fit on the SC. I went and got one. I hooked it up and sure enough it took care of the problem. I have been using this plotter for at least 5 years on usb it was only when I hit the reset that it became a problem. Are there any features in SB 7.0.0 that is worth losing my settings to uninstall 6.0.0 in order to install 7.0.0? I don't have the trial screen on my SB 6.0.0 software. I have two plotters using this software. I don't even use it that much, I all most always use my Graphtec just cannot stand having something around that does not work
I did.
I did, and removed the mainboard completely out, checked the capacitors, diodes and resistors washed it down with alcohol blew access with air and let it dry for a couple of hours.