jcsocal

There is a groove in the 4100 i've been using the run a razor blade for right now, but I think it might be big enough for that tool! Awesome recommendation!

Thanks for the quick response! I appreciate learning what the term is (cross cut) and now I can put this quest to rest! You both rock! Thanks Again!

Hi, I'm new to vinyl cutting and and this machine. I've worked through the manual three times now, but I don't see how to tell the cutter to cut the project from the material spool. I'm not sure if that makes sense, but I was able to successfully cut my project, however now I need to detach it from the spool of vinyl. I assume there is a way to tell the vinyl cutter to just cut the material off? Thanks so much in advance! JC