delboy2028

Members
 View Profile  See their activity

  • Content Count

    5

  • Joined

  • Last visited

Community Reputation

0 Neutral

About delboy2028

  • Rank
    Newbie
  1. delboy2028

    60 degree blades

    delboy2028 replied to delboy2028's topic in Creation PCUT Cutting Plotter Discussion

    thats not inch thats mm, i got them settings off another form will play around and report back.
  2. delboy2028

    advnaced after cut

    delboy2028 replied to delboy2028's topic in Signcut

    thank you gys
  3. delboy2028
    I have spent many of times getting my 45 degree blade setup perfect. Now and again its misses a bit of a cut here and there but is cuts nice. My off set is 0.25 and overcut is 0.50 on signcut which is all i use with my cr360 problem is when i use a 60degree blade it either cuts through it when i get it to cut correct it starts to peel or overlap. I have tried to adjust the overcut but to no affect. any advice welcome please.
  4. delboy2028

    advnaced after cut

    delboy2028 posted a topic in Signcut

    My CR360 does not advance after cutting with the signcut program. with flexi it advances with signcut when it finishes the weeding boarder it stops with the arm down and i have to press reset for the arm to lift and the vinyl to be released.
  5. delboy2028

    Hello from Grimsby UK

    delboy2028 posted a topic in Introductions

    Hello from grimsby UK, I have a CR360 and though i would pop over and say hello.