Appleuser

haha..no way!!!

Change motherboard and all good

The motherboard change went well.

Looks like the motherboard is used for the CE4000, CE6000 and CE12000 series... need to change some dip switches for the correct model

hehe I have an graphtec CE6000-60

Change board is easy, but does it need to re align and setup the cutter?

Has anyone of you change the motherboard on a graphtec machine?

Have not tried that formware. Just v2.10 and same problem, so I downgraded back to v1.7. And Graphtec will not help me.

Well it has the same issue with random cuts

New update The Graphtech CE6000-60 cutter works perfect now with restarting after each cutjob. Soon the power is on all time, it do random cuts.. Any ideas?? regards

Just an update! Have not got new mainboard. But I have kinda solve the problem for now. I design in AI of Graphtec studio, and power on the cutter. Then I press "Send to cutter" It do cut without any problem. When fnished cutting, I power it down. And starts all over again for each cutting. But IF it has power on all time, it starts to do random cutting For now, I am happy...

Well, same problem there. do random cut lines in signcut I guess I need a new mainboard. emailed graphtec and I am so lucky that graphtec will only send out to U.S. Addresses. and I live in Norway. Anyone knows what a new motherboard for the CE6000-60 cost? If anyone can check, I would be gratefull PN U792600750 Thanks

No, I will try signcut...

Here is the example file http://www.lasertech.no/test.gstudio I using graphtec studio or even illustrator Picture of what do happends. second line is how it can cut the file.

I use mac, and there have been no problem using mac. I have also tried on a pc, same problem there. I can make a new file, enter a text (20x30cm) and when I cut, it make random cut lines..