ElectroJesus

Thanks for the tips, I extended my blade some and cut some stars to test. So far so good.

Anyone master cutting Siser ReflectAll? It's thicker than most of the other stuff and pretty pricey, i dont know to be wasteful going through a trial and error phase.

Is there a list of recommended settings for cutting the different vinyl types?

Thanks for your response. Same settings as flock? @djque (in case tagging works here)

Newb here so bear with me. I am trying to weed a logo out of some Siser holographic heat transfer vinyl and i can't seem to weed my logo. The vinyl just rips with a little muscle and i can never seem to get any leverage to pull the extra off so its just coming off piece by piece. As a result i can't seem to get my logo to stay in one piece and on the sticky plastic sheet. In my two trial runs i've just loaded the vinyl, made my cut then began to peel as i normally would. So i am not sure i am missing a step or if i need to treat this type of vinyl differently? Any guidance is appreciated.