Having a few problems setting up the MH1351.
I tried to follow the guide that was on one of the disks but after i did that i just got error when printing errors so i decided to retry it on my laptop and this is what i have done and what i am getting.
using serial connection 9pin, set at 9600rate
i installed the print driver, the guide i have said to use Graphtec CE1000-60 drive since there isnt a MH1351 driver on there. Have it on com 1. if i hit the test print button i get a simple design that prints thats just | looking.
i have the artcut software installed but if i try to use that to print it goes through like normal print job but then nothing prints with no errors.
I originaly setup the paper size to free size and what i had in the guide but then i would just get error when printing and nothing would happen.
if i hit the test button on the device i get a simple square with a dimond in it so i take that as a good sign heh
any advice on setting this up?