-
Content Count
582 -
Joined
-
Last visited
-
Days Won
2
MrMopar64 last won the day on January 18 2014
MrMopar64 had the most liked content!
Community Reputation
47 ExcellentAbout MrMopar64
-
Rank
Advanced Member
- Birthday 10/14/1953
Contact Methods
-
Website URL
http://www.rg-kustoms.com
Profile Information
-
Gender
Male
-
Location
So. Cal.
-
How heavy of a static cling can I cut on a Graphtec 6000 I can only find 8mm Thanks in advance MM64
-
MrMopar64 started following Job we did on mothers day, Static Clings, Need this outlined.... and and 6 others
-
#2 you loose the roll bar so it looks more like a sedan... MM64
-
Aprintco Los Angeles Ca
-
Paypal has whats called VIP Access which when you log in you need the number that the program produces to enter in the box before it will open your account. The number changes every minute MM64
-
New Graphtec CE6000-60 lifting some corners.
MrMopar64 replied to efimage's topic in GraphTec Cutting Plotter Support Requests
Lower the force a number or two MM64 -
Looking for someone to make some shirts
MrMopar64 replied to MoZo's topic in T-Shirts and/ or Garments
If jaybird don't workout let me know MM64 -
If those are going on the inside of the glass they need to be cut the other way... just say'n MM64
-
Thanks! Guess I should have run the center aline by them This was what they sent to me. As far as more vinyl... lets just say the budjet was tight MM64
-
First job this week... MM64
-
Card Readers Specifically PaypalHere
MrMopar64 replied to MadHatterGraphix's topic in Off Topic Section
While talking paypal here are some rules mostly about check captour and most people don't know No checks over $1000.... If your customer owes you more have them write 2 checks Daily limit for deposit is $1000 Weekly limit for deposit is $3000 If a check gets rejected by there system you can not re-deposit it If a check gets lost in ciber space in there system you have to wait 15days before you try to re-deposit Then if the system will not take the check you must get another check I have no bank account for my business and my bank would not cash a check with my co name on it That is where I learned all this Just a few things I learned the hard way MM64 -
Graphtec 8000-130 Contour Cutting Vinyl with Masking tape
MrMopar64 replied to Shanx's topic in GraphTec Cutting Plotter Discussion
I don't know much about this. I've only conture cut printed stickers But what if you made a printed layout with reg marks and put it over your tape Then use it to set up your conture cut.... Might work MM64 -
Yeah the plotter doesn't know the difference blade or pen my graphtec has a pen setting but when I watch it work it goes through the same thing as in the blade mode MM64
-
The new graphtec does the same thing but somewhere in the set up it ask if you want it made inside or outside the job The plotter does it to set the blade to start the cut... Now I don't know for sure what software is asking for this info I just set it to outside and have had no problems MM64
-
Bent media rollers
MrMopar64 replied to express2100's topic in GraphTec Cutting Plotter Support Requests
Solid stock will bend eaiser then tubing... heavier wall tubing would be better or another small tube that just fits inside that one MM64