Trumpy

Good luck. I had no problem pulling up the cutting strip on my CE-5000. With that said, getting the adhesive off was a whole different story. I tried Goof-Off, WD-40, rubbing alcohol, anything I could find. After all that, the only thing that worked was Carburetor Cleaner. It made a mess, but it got it off. Hope this helps.

I think “Operation Mind Crime” has to be one of the best hard rock albums ever created.

I would like to be the first to wish everyone here a safe and happy Father’s Day. Al

I always got a kick out of Ford spelled backwards... Driver Returns On Foot

Make sure “Auto Pre-feed” is turned off. It’s located in the Advanced tab under Cutters (the last button on the right). Al

KVM is the way to go.

Here's one I made also. deflatsoccer.eps

Push the back arrow to retract the vinyl so the edge of the vinyl is even with the front of the cutting strip. Then push origin.

Thank you.

Thank you. I have to ask, is there any image you don’t have? Thank you again.

Thanks to both of you.

Hi all, Here’s my situation. As a joke, I made a pro union Calvin pee decal for a friend. His BA saw it and wants to buy around 200 or so to give out. I know I can’t do that legally. What I need is a variation of Calvin, or something like Calvin that will get the same point across and not infringe on any copyright. Thank you for any help or suggestions. Al

That’s what I do; I just thought there was a setting or a button that would take it back automatically. Thank you for your reply. Al

This is probably a simple thing but it’s driving me nuts. I have a Graphtec CE5000-60. I am using Corel Draw x4 with cutting master. I load my vinyl, press enter, and after it measures the width, the cutter moves to the very front right corner. After the cut, I have it advance 2” so I can use the cutting trough (I hope that is what that slot is for.). Now I want to cut another design with the same vinyl. How can I get the cutter to go back to that very front right starting position without raising the pinch rollers and starting all over? I hope this makes sense. Thank you. Al

Thank you.