tservice

I am making equipment label that is printed I will be contour cutting them, but I need to also cu a hole in the center of the print. How can I make flexi do it? Thanks guys

lol 29.00 not for me. I guess I like aggravation.

the ones there to O and G are different.

It's worth a shot I will check it out. thanks

I do not think that would work, because the DODGE is stamped in the metal. Does that make sense?

I need the dodge graphic, if anyone has it. I would just recreate it but since the vinyl is on a raised portion It would be rather difficult to just recreate it :/

I have never found a way to undo it. I always save before and after. I will contact support and see. thanks againfor your help.

that is perfect, thanks so much. idk why SAI did not include a undo for that.....

great, thanks. here it is. New folder (3).zip

under effects I only have 2 options, 1. contour cut. 2. contour cut mark :/

I have 8.6 and I have a saved file. I need to edit it. But I have to undo the contour cut outline. How do I undo that? thanks

yep I went to products, none of them struck me as a doming product...

Thanks but I get this on that page. Which product of theirs is it? Not Found, Error 404 The page you are looking for no longer exists. Perhaps you can find what you are looking for by searching the site archives by page, month, or category:

Hey guys, I tried some doming last week and it turned out nice. My only problem is the the epoxy dried hard. I need to find some that is flexible when dried. Any ideas? Thanks

yes, any usb cable will work. But imo use the serial cable. Your life will be alot easier in the long run.