Sign in to follow this  
dieselhog

pcut 630 trouble with Serial cable

Recommended Posts

HELP, I am out of Ideas.  When I originally setup this cutter I had trouble with the USB connection (my settings were goofed) so I ordered a PCI card with a 9 pin serail cable.  I installed it and have been printing with no problems using the serial connection.  This weekend, it will not work I get the device error failure to initialize message.  I can hook it up with a USB cable and it cuts fine, but nothing with the serial.  THe ports are set the same in signblazer and device manager.  I have tried both  hardware and Xon Xoff setting, and I am NOT using the cut manager.  My machine is running Vista SP1.  Can you give me any ideas on how to troubleshoot or what I might be doing wrong?  I have even removed the PCI card and reinstalled it and its drivers to see if that was the issue, but no change.

Also a Sigblazer question.  Does it remain neccesary to start and use it as a trial, or is there now a way to activate it properly?

Thanks

Todd  912-247-8960

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this