Guest sciondrgn

My first shirts~!

Recommended Posts

Guest sciondrgn

Ok so i got my SunIe heat press in today and got it all setup! I can already tell I need help with getting the transfers lined up better but these turned out pretty good!

Go easy on me now! Its my first time  :huh:???;)

I used the Siser EasyWeed.

Front left Pocket (about 5 inches tall)

1.jpg

Back of shirt (About 14 inches tall)

width=449 height=600http://www.sharpclawstudios.com/shirts/2.jpg[/img]

Share this post


Link to post
Share on other sites

looks great.  my son loves tigers. care to share the tiger image? thanks!

Share this post


Link to post
Share on other sites
Guest sciondrgn

looks great.  my son loves tigers. care to share the tiger image? thanks!

Sure I will post it up later, its out on the cutter computer and I havent gone out there yet :huh:

Share this post


Link to post
Share on other sites

Great job, I bet that tiger was fun to weed. I'm not sure the size of your platen but mine is 16x20. I make sure the garment is lined up straight on the platen, place the transfer and if I question how straight it is I measure certain points of the design to the edge of the platen. Haven't had one crooked yet. Have fun with your new "toy"

Share this post


Link to post
Share on other sites
Guest sciondrgn

A few more shirts :thumbsup:

6.jpg

Done for a local high school student

7.jpg

8.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now