pcut 630 .....not coming on at all now....

[audioman 0]

I bought this thing to have a little fun with, and now it's about to get thrown in the dumpster....

I have had this about a year, but I have not used it hardley til this evening. I cut out about 10 5" ribbons for my wife, and it stopped mid-cut, displaying "waiting". I closed out sign blazer, but no change on the plotter. I turned it off ofr a bit, then still no power. I slid the back cover off to check power going to one of the boards with my multi-meter, and power up to that. I pressed on the chip to check that they were in, and still nothing. checked all the grounds, all good

Is there anything we can do here? I spent some cash on this thing and it's useless to me now! I fi can't fix it, it'll get tossed...so much for my short lived hobby!

[lowone 3]

Is the carriage pressing on the reset button? If not you could try making sure the power switch is on while pressing both red reset switches.

Hope this helps.

[audioman 0]

thanks for the recommendation, but nothing there....

[audioman 0]

does anyone have a clue??

[kenimes 42]

No power at all to the unit? I am thinking a power supply failure. Easy part to replace.

[audioman 0]

that's what online support and I came up with.....