Sign in to follow this  
Supermandude

A couple easy questions about the refine

Recommended Posts

Im looking at the Refine MH721

It says that the max width it cuts is 24.8" im curious as to what the max length is ?

Like say could I do a car graphic 22 inches high and 100 inches long ? does it just keep feeding vinyl through the cutter ?

Share this post


Link to post
Share on other sites

You should be able to cut any length.  Make sure that the page setup is the correct size otherwise your plotter will cut tiles and you will have to piece the graphic together.  I have used my plotter to cut letters for up to 60" banners before.  Another thing to consider is vinyl alignment.  At this length, if the vinyl is fed in crooked, even just a little bit, the graphic will begin to run off the edge of the vinyl and you will have to a) start over or :thumbsup: piece another section together which will cause seem in your graphic.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this