lp 0 Posted September 22, 2008 Is there another driver besides Desay XY300P to run Master brand cutter in Flexi 8.5 Starter v2 build 1355? What I was hoping for is a generic that would run this cutter. Share this post Link to post Share on other sites
kenimes 42 Posted September 22, 2008 You could try the Roland PNC-1000 Share this post Link to post Share on other sites
lp 0 Posted October 7, 2008 Just to update on driver problem. After purchasing new cutter(but not from Desay) I discovered that if you used the Desay Tiger 1000 driver in Flexi 8.5 my Master XY300P cut with no problem. So much for bad motherboard as Desay wanted me to believe(Dave wanted to sell new motherboard at $160.00) It just goes to show that it does pay to try other drivers trial and error. Share this post Link to post Share on other sites
kenimes 42 Posted October 9, 2008 Thank you for the update. Share this post Link to post Share on other sites