chadarcy 0 Posted August 31, 2008 Could someone look at this file and explain to me why the text is not being sent when I try to do the cutting operation. I first imported a .eps of the image in this file and then added the text to it. All that sends over to cut is the wireframe of the image without the text. Thanks, Chad LOGO.SBD LOGO.SBD Share this post Link to post Share on other sites
Jay2703 704 Posted August 31, 2008 I get an error when I try to open it. Can you try to upload it again? Share this post Link to post Share on other sites
firemalt 10 Posted August 31, 2008 Got the same error as Jay Share this post Link to post Share on other sites
chadarcy 0 Posted August 31, 2008 here it is again! LOGO.SBD LOGO.SBD Share this post Link to post Share on other sites
chadarcy 0 Posted August 31, 2008 I solved my own problem by reading another post! I was not aware that you could shut off colors in the cutting screen. I had to hold shift down and click on each to get all of them to show up. Hope this helps others, and thanks for trying to help. Chad Share this post Link to post Share on other sites
Popeye 0 Posted September 2, 2008 Are you sure it isn't the "Ctrl" key? Share this post Link to post Share on other sites
PattyT 0 Posted September 2, 2008 You guys are all so good at this software! I was using the shift key and clicking on the colors to cut. It selected each color band that was between my starting point and ending point. The control key allowed me to cut color band 1 and color band 4 but not color bands 2 and 3! Thanks a bunch!!!!!!!!!!!!!!!!! I spent hours playing with that. That will make registration marks a whole bunch easier! You all rock!!!!!!!!! Share this post Link to post Share on other sites