CAN I REPEAT A CUT

[angel48e 0]

I need to repeat the same cut one on top of the other

CAN I DO THIS

[jfought 120]

do you mean one after another?

[kenimes 42]

Select how many copies in the software.

[JoeCamaro 11]

Like cutting over the already cut image?

I believe you can if the blde went back to the origin, then send it to cut again. I think it should cut exactly over the already cut image.

JC

[dkhochhalter 1]

Joe-

How do you send it back to the original origin? Memorize the x and y values? My cutter doesn't go back to the original origin, but to a new starting location at the end of my cut. This would be helpful to know incase your cutter freezes in the middle of a long cut. If you could make it "memorize" that original starting point, then it should cut exactly over what it did, and finish what it hadn't gotten to yet, correct?

[Kittycut 0]

I'm just proving yet in my recently arrived Refine with SignBlazer and if you chose to make say 4 cuts, it does them horizontaly one beside other.

If you makes one cut and then you makes another same cut, it will do it in the same origin piont.

But I don't know if there is something else. I'm just a newbie

Kittycut

[Jay2703 704]

In signblazer you have to go to Cutter Setup within the Cutter panel and uncheck the "Advance Page After Job". Then it will return to the origin.

[dkhochhalter 1]

Really? Wow, I had no idea. Thanks!