ff-extreme 6 Posted July 22, 2008 Is there a standard size when people make these or do you have to measure the door every time you do one? Share this post Link to post Share on other sites
Guest fivestar Posted July 22, 2008 I use 12"x24" but I have only did a handful. That seems to be the "normal" size I have found. Share this post Link to post Share on other sites
firemalt 10 Posted July 22, 2008 12"x18" and 18"x24" seems to be the size people ask me about the most often. Share this post Link to post Share on other sites
JoeCamaro 11 Posted July 23, 2008 BJ and FM, were do you get your blanks? Share this post Link to post Share on other sites
BannerJohn 1,324 Posted July 23, 2008 I buy by the roll. www.mumpowersignsupply.com Signwarehouse sometimes too. Share this post Link to post Share on other sites
JoeCamaro 11 Posted July 23, 2008 Thanx John. Is there a place to get them pre cut? Share this post Link to post Share on other sites
BannerJohn 1,324 Posted July 23, 2008 yeah..ME. Check your PM. Share this post Link to post Share on other sites
ralais 0 Posted July 23, 2008 yeah..ME. Check your PM. Can u PM me that 2... I want one of those magnets on my door once I figure out a design. You can PM me a design too if you want... lol Share this post Link to post Share on other sites
firemalt 10 Posted July 23, 2008 Joe... I just bought a 24"x10' roll from Fellers. This way I was able to cut sizes as needed. Plus, the first set paid for the entire roll, letting the next two pair of signs to be pure profit! The 30mil is easily cut with just a normal pair of scirrors, and then just do as JB recommends for a corner cutter(scrapbook corner cutter from Walmart(roughly $3.00). I hand trimmed my first few sets, but the corner cutter makes life that much better. Share this post Link to post Share on other sites
