riribarr 0 Posted July 20, 2008 in fact the problem I have is that when short letters or little things sometimes does not close the plotter cuts well or not well outages ends, explained to me if the letter is to cut "o" sometimes does not close the Contor not entirely by the both the vinyl I must finish cut with a knife any idea ? thanks Share this post Link to post Share on other sites
kenimes 42 Posted July 21, 2008 Offset setting in the cutting software. Which cutter do you have and which program? Share this post Link to post Share on other sites
riribarr 0 Posted July 21, 2008 signblazer the deal, as it works off the set?, I must increase or decrease the value? Share this post Link to post Share on other sites
kenimes 42 Posted July 21, 2008 In SignBlazer go to Cutter, then Setup and set the Offset to .25 Share this post Link to post Share on other sites
riribarr 0 Posted July 21, 2008 okay, ken against where I need to change the value, the question is what happens if the increase or diminished .... what is the behavior, not to be wrong? Share this post Link to post Share on other sites
kenimes 42 Posted July 21, 2008 I would increase it in incriments of .05 until your cuts close completely, if they are still failing to close at .25 Share this post Link to post Share on other sites