riribarr 0 Posted July 8, 2008 hello friends, I bought pcut in the united states and I sent him a chile, the voltage used here is 220v which is higher than for which there are 110v, I put the processor or plotter works with the two electricity Share this post Link to post Share on other sites
bk2design 1 Posted July 8, 2008 I do not see a switch on the power supply to accept 220 volt. I would recomend getting a converter. Share this post Link to post Share on other sites
kenimes 42 Posted July 8, 2008 From what I understand, the power supply wll convert for 220v, as long as you have the right type of plug convertor. Share this post Link to post Share on other sites
riribarr 0 Posted July 9, 2008 I understood Ken, what happens is that in working with USA 110volt and cable that brings plotter is to 110volt, but in chile deal 220v, and wondered if I need these tranformer 220v to 110v or plotter is layers endure the two types of electricity Share this post Link to post Share on other sites
kenimes 42 Posted July 9, 2008 Good question, I am not certain. Share this post Link to post Share on other sites
riribarr 0 Posted July 10, 2008 in the description back show: 110/220v ?? Share this post Link to post Share on other sites