ncs 0 Posted June 26, 2008 Hi I have been trying to get my new pcut ct630 to work now since I received it last week. I have made sure all the com ports were correct, and made sure the flow control was set to hardware. I am now starting to think there is a problem with the sign cut program. has anyone else experienced any problems with signcutx2? If so, how did you resolve the problem? thanks. I am very puzzled. Share this post Link to post Share on other sites
kenimes 42 Posted June 26, 2008 Which cable are you using to connect the PCut to the computer? Share this post Link to post Share on other sites
ncs 0 Posted June 26, 2008 I am using the usb cable at the present time, but I have tried both Share this post Link to post Share on other sites
kenimes 42 Posted June 26, 2008 So do you have the correct COM port selected in SignCut? Share this post Link to post Share on other sites
ncs 0 Posted June 26, 2008 Yes the usb cable is set to com1 the computer is configured to that com port as well Share this post Link to post Share on other sites
kenimes 42 Posted June 26, 2008 Is this Christopher? Share this post Link to post Share on other sites
ncs 0 Posted June 26, 2008 yes Hi Ken I got the same results. I found nothing out of place Share this post Link to post Share on other sites
kenimes 42 Posted June 27, 2008 Got your voicemail, so I will get in touch with you today. Share this post Link to post Share on other sites
