forsalevinylsigns 1 Posted June 18, 2008 Hi Im trying to install a new setup in flexisign 7.6 but uscutter is not there. Any suggestions? Thanks Share this post Link to post Share on other sites
kenimes 42 Posted June 18, 2008 For the LaserPoint to run with Flexi you need to select Creation as the manufacturer and the CT630 DMPL as the model. Share this post Link to post Share on other sites
forsalevinylsigns 1 Posted June 18, 2008 it works great I got the 48" laser point. I changed it to the ctn-1200 because its got the wider workspace but it doesnt have the dmpl at the end of the title. Is the dmpl for the contour cutting? Thanks Share this post Link to post Share on other sites
Guest fivestar Posted June 18, 2008 Nope you can't contour cut with it in Flexi, at least I couldn't figure it out today. I did however firgure out how to do it with my Refine and Flexi today. Share this post Link to post Share on other sites
kenimes 42 Posted June 19, 2008 Yes, if you have the 48" model it would be the 1200, and not the 630 like I had assumed. I have seens cases where the CT-1200 works, but cuts mirrored, but the CT-1200 DMPL did not.......not sure why. Share this post Link to post Share on other sites
TeslaCoiled 1 Posted July 7, 2013 Be "nice" if the driver sw reference (mentioned on a few postings)referred to a "pinned" or sticky posting.I'm about to try:http://start.uscutter.com/laserpoint/cutter/driverfrom http://start.uscutter.com/laserpointfrom http://start.uscutter.com/If this gives me headaches, I'm moving to Linux;http://libregraphicsworld.org/blog/entry/vinyl-cutting-on-linux-the-real-dealhttps://www.google.com/search?site=&source=hp&q=linux+vinyl+cutter+software Share this post Link to post Share on other sites