tickleburnt 0 Posted June 16, 2008 I have followed the manual instructions to setting up the USB serial port and stuff. And when i used my software VE LXi 8.0 to cut something from my PCUT630, it just says WAITING.... the whole time and it does not cut anything. Have I done something wrong? Share this post Link to post Share on other sites
kenimes 42 Posted June 16, 2008 Which model have you selected in the software? Share this post Link to post Share on other sites
tickleburnt 0 Posted June 16, 2008 actually i have fixed the problem, but i left you a message asking for a activation code for signblazer becase my cutter didnt come with it. PLease help asap. Share this post Link to post Share on other sites
PolkaDots 0 Posted September 13, 2008 Hi, I'm having the same problem... Tried different things, but nothing seem to help Feeling frustrated. HELP Share this post Link to post Share on other sites
Knobhill 0 Posted September 26, 2008 Don't expect a fix for the activation any time soon. It's been months now with no end in site. Share this post Link to post Share on other sites
kenimes 42 Posted September 26, 2008 Don't expect a fix for the activation any time soon. It's been months now with no end in site. But it is not too big of a deal if you get all of the features in Trial Mode that you would get with the activated mode anyhow.....just takes a few more seconds to open the software. Not minutes, not hours..... Share this post Link to post Share on other sites
BannerJohn 1,324 Posted September 26, 2008 Don't expect a fix for the activation any time soon. It's been months now with no end in site. thanks for reminding us...again. Share this post Link to post Share on other sites