Sign in to follow this  
tickleburnt

Cutting Problem

Recommended Posts

I have followed the manual instructions to setting up the USB serial port and stuff. And when i used my software VE LXi 8.0 to cut something from my PCUT630, it just says WAITING.... the whole time and it does not cut anything. Have I done something wrong?

Share this post


Link to post
Share on other sites

actually i have fixed the problem, but i left you a message asking for a activation code for signblazer becase my cutter didnt come with it. PLease help asap.

Share this post


Link to post
Share on other sites

Don't expect a fix for the activation any time soon. It's been months now with no end in site.

But it is not too big of a deal if you get all of the features in Trial Mode that you would get with the activated mode anyhow.....just takes a few more seconds to open the software. Not minutes, not hours.....

:)

Share this post


Link to post
Share on other sites

Don't expect a fix for the activation any time soon. It's been months now with no end in site.

thanks for reminding us...again.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this