Go-C Graphics 856 Posted August 25, 2022 Using vinylmaster. Over the many years of using the plotter I thought at some point I did this. I want to use a pen or marker in my Graphtec and have it draw a picture on some kraft paper. Of course, I can get it to do the outline of the drawing just as it would cut vinyl but I'm trying to remember how to get it to fill in the area as it's shown in the vector file. For example, I can get it to draw a square but out do I get it to fill in the square to make it a solid fill box? Does anyone know where the settings for this are? Quote Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted August 25, 2022 I know on flexi software you use the FILL option. Not outline. There are old posts on here for that. Here is one. Might be others, It looks like Fill is on higher versions of Vinyl Master. Quote Share this post Link to post Share on other sites
Go-C Graphics 856 Posted August 25, 2022 34 minutes ago, MZ SKEETER said: I know on flexi software you use the FILL option. Not outline. There are old posts on here for that. Here is one. Might be others, It looks like Fill is on higher versions of Vinyl Master. Engraver mode....... Got it. I found the setting. It's under the plugin button. I knew it was around there somewhere. Thank you MZ Skeeter 1 Quote Share this post Link to post Share on other sites
Go-C Graphics 856 Posted August 27, 2022 Well, I cheated on my son's project. I can't draw so I had the plotter do it for me. 2022-08-25 21.04.11.mov 2022-08-25 20.46.15.mov 2022-08-25 20.32.22.mov Quote Share this post Link to post Share on other sites