Go-C Graphics

How to get VM to fill in the shape when using a pen or marker

Recommended Posts

Using vinylmaster.

Over the many years of using the plotter I thought at some point I did this.  I want to use a pen or marker in my Graphtec and have it draw a picture on some kraft paper.   

Of course, I can get it to do the outline of the drawing just as it would cut vinyl but I'm trying to remember how to get it to fill in the area as it's shown in the vector file.    

For example, I can get it to draw a square but out do I get it to fill in the square to make it a solid fill box?  

Does anyone know where the settings for this are?

Share this post


Link to post
Share on other sites

I know on flexi software you use the FILL option.  Not outline. There are old posts on here for that.  Here is one.  Might be others, It looks like Fill is on higher versions of Vinyl Master.  

 

Share this post


Link to post
Share on other sites
34 minutes ago, MZ SKEETER said:

I know on flexi software you use the FILL option.  Not outline. There are old posts on here for that.  Here is one.  Might be others, It looks like Fill is on higher versions of Vinyl Master.  

 

Engraver mode....... Got it.       I found the setting.    It's under the plugin button.    I knew it was around there somewhere. 

Thank you MZ Skeeter

  • Like 1

Share this post


Link to post
Share on other sites

Your content will need to be approved by a moderator

Guest
You are commenting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...