EM Designs

Resume Cutting

Recommended Posts

I had to stop in the middle of a cut to adjust something is there a way to resume the cutting process so I don't have to start all over?  There is nothing obvious like "start" that appeared on my screen after I hit stop ... help!

Share this post


Link to post
Share on other sites

Although the answer given by Mz.Skeeter is accurate, I would venture to say that in some isolated cases, there's a workaround available, depending on the design.

For instance, if the cut involves all text, you can go back to the original and perform an edit, leaving only what is not cut yet. Then, set the new beginning of your cut (origin) to commence where you left off.

 

maybe.JPG

may be.JPG

Share this post


Link to post
Share on other sites

A Graphtec, you can stop. It has a HOLD button on the Control panel.   Then >continue or clear.   But if you lift the media handle, you are done..  I noticed the OP was listing under Prismcut.  

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now