Tovar 0 Posted August 10, 2021 Hello everyone! I am looking for help to identify this Vinyl Cutter that I have. I will attach a few pictures of it. Thanks in advance! Share this post Link to post Share on other sites
slice&dice 2,450 Posted August 11, 2021 It's a standard Chinese cutter, you can run it with SignBlazer and USB (if you don't have a cable with it, any regular printer usb cable will work). Choose Liyu or RedSail in cutter setup, and you should be good to go. Share this post Link to post Share on other sites
darcshadow 1,625 Posted August 11, 2021 What's the "Leave" button on the control panel do? That what you press when you're fed up and done for the day? ha 2 Share this post Link to post Share on other sites
slice&dice 2,450 Posted August 12, 2021 I wonder if the O-P was trying to just get his unidentified machine to run, or was seeking info on the functions? The settings (red button) would not be pressed in general, no need for it in regular operations. "Leave" is essentially "Offline" ---- to adjust the x & y axis movement with the arrow/directionsl keys and place the vinyl and carriage head in position (then hit "Origin" to set). I would run up the speed to max (up arrow) which is likely 800. ---- I never reduce speed from max, let 'er rip! The force is dependent on the media/vinyl, and if the blade is properly adjusted, a test cut will determine what exactly to adjust this value at (90 might be a better starting point). By the way, it's a VEVOR branded unit. Share this post Link to post Share on other sites
Sally Young 1 Posted August 12, 2021 11 hours ago, slice&dice said: I wonder if the O-P was trying to just get his unidentified machine to run, or was seeking info on the functions? The settings (red button) would not be pressed in general, no need for it in regular operations. "Leave" is essentially "Offline" ---- to adjust the x & y axis movement with the arrow/directionsl keys and place the vinyl and carriage head in position (then hit "Origin" to set). I would run up the speed to max (up arrow) which is likely 800. ---- I never reduce speed from max, let 'er rip! The force is dependent on the media/vinyl, and if the blade is properly adjusted, a test cut will determine what exactly to adjust this value at (90 might be a better starting point). By the way, it's a VEVOR branded unit. Good to know about the "Leave" button. Share this post Link to post Share on other sites
kainth.c.s 53 Posted August 16, 2021 On 8/10/2021 at 10:42 AM, Tovar said: Hello everyone! I am looking for help to identify this Vinyl Cutter that I have. I will attach a few pictures of it. Thanks in advance! It looks like a chinese imitation of a vevor branded cutter Share this post Link to post Share on other sites
bigbull 1 Posted September 30, 2022 i have the same unit but finding it hard to find the drivers for it Share this post Link to post Share on other sites
slice&dice 2,450 Posted September 30, 2022 With SignBlazer, you shouldn't have any trouble. Share this post Link to post Share on other sites
darcshadow 1,625 Posted October 3, 2022 And if you use the serial connection you don't need drivers for the cutter. Share this post Link to post Share on other sites