TOa 0 Posted May 22, 2021 Can anyone help... I need to know what driver to get for a cutter plotter 1351 and where to download it from. Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 22, 2021 1351 is not the cutter brand. It is the width of the cutter 48- 50 inches.. What is the cutter/plotter brand? Where did you purchase it? Which cutting software are you using with this cutter? Share this post Link to post Share on other sites
TOa 0 Posted May 24, 2021 Got of from eBay. No brand on it at all, just the information in the images I've attached. Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 24, 2021 Then why aren't you asking the Ebay seller? Can you show the ad? Share this post Link to post Share on other sites
darcshadow 1,626 Posted May 24, 2021 Most likely a the generic FTDI driver is what you need to be able to talk to it. Or you could use the serial port and not worry about drivers. 1 Share this post Link to post Share on other sites
slice&dice 2,450 Posted May 24, 2021 In SignBlazer cutter setup, choose the RedSail or LiYu models and see if the cutter responds. 1 Share this post Link to post Share on other sites
