LouLouNovice

Graphtec CE6000-40 Sensor Offset Adj

Recommended Posts

Hi - complete novice here!  having recently 'inherited' this Graphtec cutting plotter, and I am starting from scratch learning via tutorials and videos and now joining forums!!

attached photo shows the X + Y axis and you may be able to see the cut line.  initially this cut line was 5mm out and I have located within the arms settings how to adjust, BUT it will only allow for a 3mm tolerance (so now shows that it is 2mm out)  

Is there something else that I have not considered or is this the only way of aligning these axis to the correct points?  

any suggestions welcome 

IMG_20210513_140236_resized_20210513_021549736.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now