salih111 0 Posted April 9, 2021 After a finish small job, ms SC2 just shot down after several beeping sound that I didn't know where it was coming. Now my cutter doesn't start no light. Unplugged and plugged in but no luck! Any help appreciated! Thanks, Share this post Link to post Share on other sites
Wildgoose 4,200 Posted April 9, 2021 46 minutes ago, salih111 said: After a finish small job, ms SC2 just shot down after several beeping sound that I didn't know where it was coming. Now my cutter doesn't start no light. Unplugged and plugged in but no luck! Any help appreciated! Thanks, Did you make sure the red button over on the far side did not get hit by the carriage or by some other accidental means? Share this post Link to post Share on other sites
slice&dice 2,450 Posted April 9, 2021 The SC2 does not have a 'red button' on the right side. The 'limiter switch' (what the 'red button' functionality would be) is located within the top rail; it's an optical sensor that reads the carriage travel. When the carriage reaches the Notch in the rail, it recognizes that point as being at the end. It's fairly simple to access this by removing both endcaps, then releasing two screws holding onto the top rail and then tilting it back. Share this post Link to post Share on other sites