Sign in to follow this  
MDesigns

Contour cutting on SC2 WITH Mac and SC4

Recommended Posts

So I have had some success. Funny enough the people at Craft Edge said contact US cutter lol. Oh the old ping pong support game. Ill get it sorted eventually! I think I have a set of steps for any users who might be struggling as well.

Share this post


Link to post
Share on other sites

These directions were exactly what I needed. I tried to calibrate the machine myself initially. Which did work. But the method described here takes all the guess work out about the cutter offset!

This was super helpful (wish I had remember to look here this morning!)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this