Sign in to follow this  
jmassprinting

Blade Not Raising From Vinyl When Moving To Next Location

Recommended Posts

new or old laserpoint?   lp1 or lp2 - are you just setting up for the first time??  

Share this post


Link to post
Share on other sites

new, 

3 minutes ago, Dakotagrafx said:

laserpoint novo ou antigo? lp1 ou lp2 - você está configurando pela primeira vez ??  

new Laserpoint3 was working normally.

Share this post


Link to post
Share on other sites

if you are original purchaser I would call support - did you have the stand grounded to the bottom of the plotter - haven't seen it as much on the lp3 but then again not a lot of them out there from what we see on the forum.   could be mainboard, connection, or solenoid - either way it would be support that has the checklist to run thru to narrow it down

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this