keith20mm 0 Posted December 8, 2020 Is there some way to set CM4 to enter a cut from a particular vector's end, and with a particular cutting direction?I have a cut job where I would like to approach the target vector with a spiral entry, and the reason is I am cutting some 0.0007" mylar clear film, the media tends to get a raised edge at the cut. I am attempting to achieve a smooth edge cut, no raised bead.The blade is a new 60-degree carbide, and speed is rather low, pressure is around force 17. I have tried cutter pressure both above and below, and tried various speeds.I am cutting with Graphtec CE6000. Share this post Link to post Share on other sites