How wide is the useable cutting area on the MH365?

[blakemail 1]

I have an MH365 which is listed at a 14" cutter.  I made a design that is 10 inches wide and loaded 12 in wide Oracal vinyl into the cutter.  When it made the cuts the image was the width I expected but part of the cuts were over other cuts.  It's almost like I told it to make a 10 in wide image but it can only cut 9 inches wide so it pushed part of the image together.  If I rotate the image it cuts fine because then it's only 2 inches wide.  The image in question is about 10x2.

So my question is how wide of an image can the MH365 cut?

 

[MZ SKEETER 4,709]

Specs  state  on the UScutter site.    

MODEL	14"	28"	34"	50"
Maximum Cut Width	10"