dburns1978 0 Posted September 1, 2020 Have an SC2 with Vinylmaster Cut software, when cutting a series of numbers, it keeps overlapping. it's like it slips on the rollers, the bottom number in the picture is supposed to be an 8. Any ideas? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted September 1, 2020 Make sure that the pinch rollers are over the grit rollers on the bottom. Never be pulling from a roll while cutting. Always have enough vinyl prefed and free. Other than that you don't give enough info of what you are doing. Or showing how you have the vinyl in the vinyl cutter. Put pinch rollers equal distance from the vinyl edge. 2 Share this post Link to post Share on other sites
haumana 1,220 Posted September 3, 2020 having the pinch rollers jerk the vinyl off of a roll because there wasn't sufficient slack is not a good thing. 1 Share this post Link to post Share on other sites