danielellis 0 Posted August 1, 2020 hi so i changed the usb d port today took the main board off to do so and re assembled but pen does not work under test or in main menu ? any ideas please thanks Dan Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 1, 2020 I would reseat all the connections - the carriage (if referring to the blade holder not dropping) cable could be not seated or slightly ajar - hopefully you had static protection on your wrist and didn't damage the mainboard - rarely happens but seen it lots more on printer mainboards than plotters Welcome from the USA Share this post Link to post Share on other sites
danielellis 0 Posted August 2, 2020 thanks yeah been through the connectors etc and no i didn't ;( hoping its not that going to check if the down pressure has gone to zero later as i did a reset too thanks Share this post Link to post Share on other sites