Ginchgonch72 0 Posted May 14, 2020 New machine but the pinch rollers don’t move easily. I feel like I have to put a lot of force to get it into position? Any advice? Share this post Link to post Share on other sites
haumana 1,220 Posted May 15, 2020 if you cut the same width vinyl the majority of the time, then figure out the best position and try to stick with that setup. Some machines are just more difficult than other to scoot the pinch rollers. Just do not accidentally adjust the tension on the pinch rollers. 2 Share this post Link to post Share on other sites
Wildgoose 4,200 Posted May 15, 2020 Oh gosh I would use some teflon dry film lubricant that won't drip and won't attract dust. 2 Share this post Link to post Share on other sites
slice&dice 2,450 Posted May 15, 2020 You mean, like this wd40 product? 2 Share this post Link to post Share on other sites
signyouup 178 Posted May 20, 2020 Did you raise the rollers first? 1 Share this post Link to post Share on other sites
