Cliff P 0 Posted April 29, 2020 Good morning all, newb here :) Just received my Titan 2 28" cutter, and was wondering if it's possible to cut from 8.5x11" printed vinyl? I printed with registration marks, however when trying to align for the 3rd registration mark it obviously spits the page out into the bin. I was thinking that maybe I could use a 1yd x 12in piece of vinyl and apply the pages to the vinyl with painters tape or hobby tape, and then do the registrations successfully and cut the decals out of the letter-sized inkjet vinyl? I'm attempting to contour cut 6 decals on a single sheet of letter-sized medium. Thanks in advance for any suggestions. Looking forward to learning the ins and outs of your trades! Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted April 29, 2020 Many people use an adhesive carrier mat. Can be picked up at several locations. And different sizes. https://www.uscutter.com/Large-A4-Vinyl-Cutter-Carrier-Sheet-Cutting-Mat Share this post Link to post Share on other sites
Cliff P 0 Posted April 29, 2020 2 hours ago, MZ SKEETER said: Many people use an adhesive carrier mat. Can be picked up at several locations. And different sizes. https://www.uscutter.com/Large-A4-Vinyl-Cutter-Carrier-Sheet-Cutting-Mat Many thanks for that! Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted April 29, 2020 2 minutes ago, Cliff P said: Many thanks for that! Your welcome Share this post Link to post Share on other sites