teddyu 2 Posted November 26, 2019 I replaced my Zchip and still no blade up and down! Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted November 26, 2019 7 minutes ago, teddyu said: I replaced my Zchip and still no blade up and down! Follow thru with this. Answer each question. https://support.uscutter.com/support/solutions/articles/14000030226-my-carriage-arm-is-not-moving-up-and-down- Share this post Link to post Share on other sites
teddyu 2 Posted November 26, 2019 Don’t see any questions when I go to the link. Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted November 26, 2019 38 minutes ago, teddyu said: Don’t see any questions when I go to the link. Slide the page down til you do. That page scrolls down. Share this post Link to post Share on other sites
teddyu 2 Posted December 1, 2019 Was a disconnected cable. put a new display in and knocked one of the cables off didn't know it so I replaced z chip did not help so I took back apart and found the cable unplugged... plugged it back up and runs fine now! I now have 20 good z chips if anyone needs one. 1 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted December 1, 2019 thanks for getting back and letting us know - might very well help someone in the future!! Share this post Link to post Share on other sites