Leann M 0 Posted October 17, 2019 Good morning! So in using our cutting machine the cuts are not completing after each letter/ design. From where it starts, it is not going back and connecting the cut, leaving a few mm still attached. I hope this makes sense and someone maybe can HELP!!! Thanks Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted October 17, 2019 that is unusual for a graphtec - which model do you have and what cutting software are you using? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted October 17, 2019 Make sure you have your blade depth set correctly. This is how. To start with, you should set your blade depth correctly, by taking the blade holder out of the machine, and firmly cut across a piece of scrap vinyl, you will be cutting. You should only be cutting the vinyl and barely a mark on wax paper backing, Adjust blade to get there, Then put the blade holder back in machine, and use the force of the machine to get there, same results, only cutting the vinyl and barely a mark in wax paper backing. You should just barely see and feel your blade tip out of the blade holder. 1 Share this post Link to post Share on other sites