Heathw 0 Posted September 12, 2019 Whenever I start a cut the first 2 letters are up higher then it picks up and does the rest of the decal right. Does anyone know what’s causing this? Share this post Link to post Share on other sites
Wildgoose 4,200 Posted September 12, 2019 We will need more info. What cutting program are you using? Is this on every job or just one? If it's not copyright protected up load the cut file in EPS format and we will take a look. Share this post Link to post Share on other sites
Heathw 0 Posted September 12, 2019 It’s the vinyl master LTR V4.0. It wasn’t doing this at the beginning. It just started every test piece of vinyl I’ve run which is about 10 pieces it has done it Share this post Link to post Share on other sites
Heathw 0 Posted September 12, 2019 It’s post to say Works the S and K are messed up then after that it cuts the rest out like it’s post to be Share this post Link to post Share on other sites
Wildgoose 4,200 Posted September 12, 2019 Have you looked at the file in wireframe to be double sure that the file itself is good. Of you are cutting scraps have you told the cutter what size of material scrap you are cutting on? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted September 12, 2019 What is the big gouge at the top of both K's? What kind of vinyl??? looks a lot like the blade is cutting thru the vinyl on the top of the k and top of the s and causing slippage - like the blade is set with too much exposure . . . . Share this post Link to post Share on other sites