gpau 0 Posted June 15, 2019 Hi, I would like to install the signcut pro 2 software, I downloaded the demo, but I can't find my MH-365 cutting plotter. How can I configure it, is it compatible with this version? How do I solve it? Thank you Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted June 15, 2019 In the cutter list , look for UScutter MH365. Or Refine MH365 Or try Redsail vinyl cutter Share this post Link to post Share on other sites
Wildgoose 4,200 Posted June 15, 2019 Here is a list of compatible cutters. http://www.signcutpro.com/files/pdf/driverlist20130410.pdf If for some reason you can't find it SignCut has actual tech support accessible from their website. I use the older version Pro 1. Signcut kicks butt 1 Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted June 15, 2019 Yes, I see USCUTTER REFINE MH365 on the list. Share this post Link to post Share on other sites
therese@whisqu.se 17 Posted July 4, 2019 Hi, Therese at SignCut here. I just want to check in and let you know that a new website has been launched. I hope you find information easier on this website then the old one. @gpau, did you manage to set your cutter up with SignCut? If not please visit our livechat and we can help you through a remote session.@Wildgoose. In the image you can see two ways to contact us on our website. If you don't find them there are other ways for example sending an email at support@signcutpro.com or if you prefer visit our Facebook and send us a message there and a support request is also created.Have a good day all of you. Regards, Therese 2 Share this post Link to post Share on other sites