923customdesignco 0 Posted May 20, 2019 Hello, I have been cutting vinyl and HTV with no problem but then here comes the cardstock, making look like I don't know what I'm doing. Ha. I am trying to cut out invitations and cupcake toppers with my MH-871 and I am unsure of the settings I need to use. I have a cutting mat for it and I installed the 60 degree blade, but I am having trouble getting it to cut all the way through without two passes and for some reason it is shifting just a tiny bit and making it to where there are two cuts instead of just going through the same path twice. Help please! Share this post Link to post Share on other sites
haumana 1,220 Posted May 20, 2019 The lower end cutters tend to drift because they just don't track as well. How are you cutting it twice? - are you sending it to the cutter twice, or do you have the design layered in your software? When I have to make multiple passes, I always layer and send it to the cutter once. I got much better results from my LP that way. 1 Share this post Link to post Share on other sites