Brett M 0 Posted April 17, 2019 I have a hp latex 64 cutter which I think is a suma rebranded. Anyways cutter has been fine but now everything I cut is off the mark by like a good quarter inch. It's reading the reg marks fine sometimes for some reason I get the digitize point always in the top left corner but then i can just move the opos over the reg mark and it works. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 17, 2019 I would contact your dealer - I don't know of anyone on this forum with experience with that plotter Share this post Link to post Share on other sites